_ DEC-O-LOG for KA47 _ DOL, KA47-F002 SEP 94 APPLICABILITY: This "F" coded FCO should be installed in all Microvax 3100 Model 30, 40, and 80 which contain part rev. below "M02" or "M03" for FRU 54-20654-01 (Model 30 and Model 40) and part rev. below "J02" or "J03" for FRU 54-20652-01 (Model 80). This FCO incorporates ECO No. 54-20654-TWO007 for Model 30 and Model 40 and ECO No. 5420652-TWO006. Please do not make a separate trip to install FCO unless customer is down. Install the FCO at the next scheduled visit. PROBLEM & SYMPTOM: Previous revision FRU does not see RZ26L and RZ28 drives, if present when booting the system. This problem is caused by SCSI RESET too short. This FCO will also correct: 1. MOP SYSID broadcasting alternates MOP3/MOP4 message, 2. SCSI Verify command now with greater than 64K block count size, 4. New VMB addresses MOP4 response time issues. SOLUTION: Replace two Firmware ROMS located on FRUs 54-20654-01 and 54-20652-01. For FRU 54-20654-01: Replace ROM 23-266E8-00 or ROM 23-223E8-00 or ROM 23-149E8-00 at location E167 with new ROM 23-284E8-00 and replace ROM 23-267E8-00 or ROM 23-224E8-00 or ROM 23-150E8-00 at location E168 with new ROM 23-285E8-00. For FRU 54-20652-01: Replace ROM 23-266E8-00 or ROM 23-223E8-00 or ROM 23-149E8-00 at location E15 with new ROM 23-284E8-00 and replace ROM 23-267E8-00 or ROM 23-224E8-00 or ROM 23-150E8-00 at location E16 with new ROM 23-285E8-00. QUICK CHECK: For FRU 54-20654-01: KA45-A V1.4-38D-V4.2 appears on screen during power up self test. For FRU 54-20652-01: KA47-A V1.4-38D-V4.2 appears on screen during power up self test FCO KIT ORDERING: EQ-01704-01 ROMS 23-284E8-00 and 23-285E8-00 36-19208-03 "3" Brady Marker 36-19208-02 "2" Brady Marker 36-19209-10 "J" Brady Marker 36-19209-13 "M" Brady Marker FA-05041-01 FCO Document