_ DEC-O-LOG for LQP45 _ DOL, LQP45-I001, PRINTER OCT 87 PROBLEM: 1. LQP45-B used with Corporate version of RAINBOW/WPS+ or ALL-IN-1. a. LQP45 does not interpret ESC[;4m and ESC[;1m. b. Character " (042 octal) is interpreted as a terminator. c. LQP45 cannot work properly in proportional mode with LQP02 printer driver. 2. Country Specific Requests: a. Characters A with ring and lower- case o with / is not correct for Denmark. b. teletex Function for Germany. c. Orator and OCR-B fonts. Symptoms: 1. LQP45-B used with the Corporate versions of RAINBOW/WPS+ or ALL-IN-1: a. Underline and bold printing do not work. b. Extra characters are printed. c. Tabs are lost. Part affected by problem: Printer Firmware: a. Printer Controller EPROM R1.0 (DEC. P/N 29-26187 Vendor P/N 723850 E PBWP) or R1.1 (DEC. P/N 29-26624 Vendor P/N 728386 E PCUW on AT131 Main Logic Board. b. Character Generator EPROM R1.0 or R1.1 (DEC. P/N 29-26186 Vendor P/N 723849 H PBWN) on IF 226 Serial Interface Board. FIELD EFFECTIVITY: This FCO covers ECO no. 3024268-00001 (ETBU LQ 0001) and ECO no. 3027268-00001A (ETBU LQ 0003). It applies to LQP45-Bs, with serial numbers lower than 1299 and Firmware Release R1.0, used mainly in the UK area with the Corporate Versions (i.e. not B.E.V. or local language versions) of RAINBOW/WPS+ or ALL-IN-1. It should only be used where problem/symptoms (1) exits. This FCO integrates into the LQP45 some new features and capabilities. a. Specific Daisywheel family for Denmark and Norway. b. Teletex Function mainly for Germany. c. Orator and OCR-B fonts. d. ASF Bin Selection from printer console DIP-Switch in self-test mode. It should mainly be used in Denmark for LQP45-Bs with S.N. lower than 2092 and Firmware Release R1.0 and R1.1. This FCO has to be installed in all CSCs and ILCs LQP45-B units in order to phase them with the LQP45s R2.0 delivered, and the new revisions of the LQP45 Videotape Training and F.S. and user Documentation. QUICK CHECK: Any of the following indicate that this FCO is not needed. a. Self-test printout shows new FW EPROMs release level 2.0 or higher. b. Printer technical level label shows number 2 crossed. c. Firmware EPROM labels show R2.0 and PCUQ for Printer Controller EPROM and R2.0 and PCUR for the Character Generator EPROM. d. LQP45-B Printer serial number greater than 2091. e. LQP45-A Printers. FCO KIT ORDERING: EQ-01483-01 FCO, PARTS FA-04773-01 FCO only